Main Broom Disassembly/Assembly - Clarke BSW 28 Libro De Instrucciones

MAIN BROOM DISASSEMBLY/ASSEMBLY

CAUTION!
It is advisable to use protective gloves when
replacing the main broom because there can be
sharp debris between the bristles.
1. Drive the machine on a level ground.
2. Turn the main switch (1) to "0".
3. Remove the hopper (9).
4. Loosen the handwheels (A, Fig. 5) completely on the left
side of the machine.
5. Remove the lid (A, Fig. 6) by grasping it on the points (B).
6. Grasp the main broom (A, Fig. 7) on the points (B) and
(C), then disconnect it from the drive hub (D) by pulling it
in the direction shown by the arrow (E); then remove it in
the direction shown by the arrow (F).
7. The new main broom must be installed with the bristles
rows bent as shown in the figure.
8. Install the new broom by performing steps 3 to 6 in the
reverse order.
9. Adjust the height of the new broom according to the
procedure shown on the previous page.
D
Operator's Manual - BSW 28
C
F
E
Figura 7
A
Figura 5
A
B
Figura 6
A
ENGLISH
S311354
S311355
B
S311356
13