How To Enable Options - Kingston DataTraveler 2000 Guia De Instalacion

1. Press KEY button once
2. Within 10 seconds, start to enter the User PIN
(default - 11223344) to unlock the DT2000
3. Press KEY button once
4. Press the KEY button twice
(double-click)
5. Within 10 seconds, begin to enter
the new User PIN
6. Press the KEY button twice
(double-click)
7. Within 10 seconds, begin to re-enter
the new User PIN
8. Press the KEY button twice
(double-click)
Note: If you make a mistake while defining a new User PIN or do not complete the
procedure, the drive will retain the old PIN.

5. How to enable Options

Options Mode allows you to perform different functions, such as enabling or disabling the DT2000
as 'Read-Only', setting a 'Timeout' automatic lock and determining the version of the device.
The table below illustrates how to access the Options mode, sections 6 - 9 describe how to perform
the various functions.
The table below illustrates how to access the Options mode, sections 6 - 9 describe how to perform the various functions.
Instructions
1. Press KEY button once
2. Within 10 seconds, enter the User PIN
(default - 11223344) to unlock the
DT2000
3. Press KEY button once
4. Press the KEY button 3 times
(triple-click)
Document No. 480ADT2000.A00
Red, Green
once and then the
blink
Red LED will continue to blink
Red solid LED changes to
indicating successful default User PIN entry
Blue LED blinks
Blue LED continues to blink
Green LED blinks
Green LED continues to blink
Red solid LED changes to
indicating that the User PIN change was
successful
LED LED State
Red, Green
once and then the
to blink
Red LED will continue to blink
Red solid LED changes to
indicating successful User PIN entry
Green and Blue
new instructions in OPTIONS Mode.
DT2000
& Blue LEDs will flash together
Red LED will continue to
Green
Green
& Blue LEDs will flash together
Red LED will continue
Green solid LED
LEDs blink together – awaiting
solid LED
solid LED,
Page 7 of 17