How To Enable Read-Only Mode; How To Enable Read/Write Mode - Kingston DataTraveler 2000 Guia De Instalacion

6. How to enable Read-Only Mode

The DT2000 has a read-only mode that restricts write access to the drive. This is enabled by performing
the following steps.
Instructions
1. Unlock DT2000 with the User PIN
2. Enable Options by pressing the KEY button
3 times (triple-click)
3. Within 10 seconds, begin to press number
7 (pqrs) followed by the number 6 (mno)
button (76)
4. Press KEY button once
Once activated, access is limited to read-only until write protect is disabled.
Note: We have applied a naming convention to make it easy for you to remember the
keystrokes for each optional setting. In the table, above we have used numbers that represent
the 'first letters' of the optional feature name. For example, Read-Only = 7 (pqrs) 6 (mno).

7. How to enable Read/Write Mode

Restricted write protect (read-only) access can be turned off with access restored to read/write.
This is enabled by performing the following steps.
Instructions
1. Unlock DT2000 with the User PIN
2. Enable Options by pressing the KEY button
3 times (triple-click)
3. Within 10 seconds, enter the number 7
(pqrs) followed by the number 9 (wxyz)
button (79)
4. Press KEY button once
Once activated, access is restored to the default read/write state.
Document No. 480ADT2000.A00
LED LED Status
Red solid LED changes to
indicating successful User PIN entry
Green and Blue
instructions in OPTIONS Mode.
Green and Blue
Blue LED quickly fades out to a solid
DT2000 is inserted into a USB port, the
blinks every two seconds indicating the drive is in
Read-Only Mode
LED LED Status
Red solid LED changes to
indicating successful User PIN entry
Green and
new instructions in OPTIONS Mode.
Green and
Blue LED quickly fades out to a solid
when DT2000 is inserted into a USB port, the
Green LED blinks every two seconds indicating
the drive is in Read/Write Mode
DT2000
Green solid LED
LEDs blink together – awaiting new
LEDs continue to blink together
Green
Green solid LED
Blue LEDs blink together – awaiting
Blue LEDs continue to blink together
- when
Green LED
Green -
Page 8 of 17