Preface; Notices; Description; Technical Data - Nederman MagnaTrack ST Manual De Instrucciones

EN MagnaTrack ST
1

Preface

This manual is for the correct installation, use and maintenance of this product.
Read it carefully before using this product or carrying out maintenance.
Replace the manual immediately if lost.
This product has been designed to meet the requirements of relevant EC
directives. To maintain this status, all installation, repair and maintenance
work for this product is to be carried out by qualified personnel using only
original spare parts. Contact the nearest authorized distributor or Nederman for
advice on technical service and obtaining spare parts.
Nederman continuously improves its products' design and efficiency through
modifications, and reserves the right to do so without introducing these
improvements to previously supplied products. Nederman also reserve the right
to, without previous notice, modify data and equipment as well as operating
and maintenance instructions.
2

Notices

This document contains important information that is presented either as a
warning, caution or note. See the following examples:
WARNING!
Warnings indicate a potential hazard to the health and safety of personnel, and
how that hazard may be avoided.
CAUTION! Type of risk.
Cautions indicate a potential hazard to the product but not to personnel, and
how that hazard may be avoided.
NOTE!
3

Description

3.1

Technical data

Table 3-1: Technical data
MagnaTrack ST
Mounting height
User speed
Airflow, engine size 0–4 litres
Airflow, engine size 4–10 litres
Pressure drop at 400 m
Pressure drop at 1000 m
Hosediameter
Material, hose (overrunnable)
Material, rail
Temperature resistance, hose
Transformer, secundary voltage
Transformer, power consumption
Transformer, capacity
Power supply
12
Type of injury.
Notes contain other information that is important for personnel.
/h (250 cfm)
3
/h (600 cfm)
3
3–4 m (10–13 ft)
10 km/h (6.3 mph)
400 m /h (250 cfm)
3
1000 m /h (600 cfm)
3
300 Pa (1.2 in wg)
1550 Pa (6.2 in wg)
125 mm (5")
EPDM/PP coated fabric (thermoplastic)
aluminium
150 C (300 F)
° °
26 V DC
0.1 A
5 VA
230 V AC, 1~ or 115 V AC, 1~