Metra 95-8215S Instrucciones De Instalación

Toyota avalon 2005-2010

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Installation instructions for part 95-8215S
Toyota Avalon 2005-2010
KIT FEATURES
• Double DIN radio provision
• Painted silver to match factory dash
KIT COMPONENTS
• A) Radio trim panel • B) Brackets • C) (4) #8 x 3/8" Phillips screws • D) HVAC harness included (not shown)
A
B
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • HVAC harness included • TYTO-01 interface or 70-1761 harness
• ASWC-1 steering wheel control interface
Antenna Adapter: • Not required
METRA. The World's best kits.
95-8215S
C
1-800-221-0932
Dash Disassembly
– Toyota Avalon 2005-2010 .................................... 2
Kit Assembly
– Double DIN radio provision ................................... 3
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver
• Socket wrench
CAUTION: Metra recommends disconnecting the
negative battery terminal before beginning any
installation. All accessories, switches, and especially
air bag indicator lights must be plugged in before
reconnecting the battery or cycling the ignition.
NOTE: Refer to the instructions included with the
aftermarket radio.
metraonline.com
© COPYRIGHT 2004-2014 METRA ELECTRONICS CORPORATION
Table of Contents

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Metra 95-8215S

  • Página 1 Installation instructions for part 95-8215S Table of Contents Toyota Avalon 2005-2010 95-8215S Dash Disassembly – Toyota Avalon 2005-2010 ........2 Kit Assembly – Double DIN radio provision ........3 KIT FEATURES • Double DIN radio provision • Painted silver to match factory dash KIT COMPONENTS •...
  • Página 2: Dash Disassembly

    95-8215S Dash Disassembly 1. Unclip and remove small trim 3. Unclip and remove entire panel piece from left side of panel above surrounding radio including A/C steering wheel. (Figure A) controls. (Figure C) 2. Unclip and remove panel above 4. Remove (4) 10 mm bolts securing steering wheel.
  • Página 3: Kit Assembly

    4. To make room for the new radio 3. Locate the factory wiring harness (Figure A) and kit, cut the center section out in the dash. Metra recommends Area to be cut out of the factory panel careful not to using the proper mating adapter remove the mounts for the factory from Metra or AXXESS.
  • Página 4 Installation instructions for part 95-8215S NOWLEDGE IS OWER Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.installerinstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow.
  • Página 5: Características Del Kit

    INSTRUCCIONES DE INSTALACIÓN PARA LA PIEZA 95-8215S Indice Toyota Avalon 2005-2010 95-8215S Desmontaje del tablero – Totota Avalon 2005-2010 ........2 Ensamble del kit – Provisión de radio doble DIN ........3 CaraCterístiCas del kit • Provisión de radio doble DIN •...
  • Página 6: Desmontaje Del Tablero

    95-8215S Desmontaje del tablero 1. Desenganche y quite la pequeña 3. Desenganche y quite todo el panel pieza de moldura del lado que rodea el radio, incluyendo los izquierdo del panel sobre el controles del aire acondicionado. volante. (Figura A) (Figura C) 4.
  • Página 7: Ensamble Del Kit

    El área a ser cortada panel de fábrica, teniendo cuidado 3. Ubique el arnés de cableado de no quitar los montajes de la de fábrica en el tablero. Metra puerta de fábrica. (Figura B, C) recomienda el uso de un adaptador (Figura B) adecuado de acoplamiento de Cableado de arnés de HVAC...
  • Página 8 INSTRUCCIONES DE INSTALACIÓN PARA LA PIEZA 95-8215S EL CONOCIMIENTO ES PODER NOWLEDGE IS OWER Mejore sus habilidades de instalación y fabricación Enhance your installation and fabrication skills by inscribiéndose en la escuela de dispositivos electrónicos enrolling in the most recognized and respected mobile electronics school in our industry.

Tabla de contenido