Abus Secvest FUBE50001 Manual Del Usuario página 39

Installation and start-up
as well as how frequently they are being carried out via the control panel! The length of
battery life when operating without an external power supply and under the following
conditions is roughly one year: arming 3x daily, disarming 3x daily, Prox calibration once
daily (automatic process), no exit time programmed.
LED test/software version display
If the tamper contact is open when the control panel starts up, the following
LED test will be performed and the software version displayed.
(1.) All four status LEDs (sub-areas 1 to 4) flash red to confirm that they are
working.
The software version of the control panel is displayed in sequence by the
red "RF TX" and the green "TEST" LED. Both LEDs are located on the PCB
close to the DIP switch.
(2.) The red transmitting LED (RF TX) indicates the major software version.
(3.) The green test LED (TEST) indicates the minor software version.
Example: 2 x flashing "RF TX" (red)
version "2.5"
If the tamper contact is closed when the control panel starts up, the
aforementioned tests will not be performed.
Automatic calibration of the chip key reader
If the DIP switch 6 (chip key reader) is activated when the control panel starts up, calibration
will be performed automatically as soon as the LED test is completed and the software version
is displayed.
During the calibration of the chip key reader, the status LEDs for sub-areas 1 to 4
light up one after the other (sequence of lights from top to bottom).
14 EN

5 x flashing "TEST" (green)

Software