Fagor HM-480 X Manual De Utilización página 88

99628993_ML_A.qxd 04/05/04
Connecting up
As a specialist, you alone are competent to install and connect up Fagor
appliances.
Our guarantee therefore applies only and exclusively to appliances which have
been installed and connected up by you in accordance with the provisions of
current regulations.
Failure to meet this requirement would incur the fitter's liability and release the
Fagor company from any liability.
Electrical connections must be made as per the connection plate fixed to the back of
the appliance, by an electrical fitter. Who must ensure that the appliance has been
connected up in accordance with fitting instructions and local regulations.
Where the appliance is not connected to the mains electricity supply by a plug, an
omni polar cutout device (with a contacts gap of at least 3 mm) must be fitted on the
supply side of the connection to meet safety requirements.
NOTE: When power is connected, the electronics of the oven are initialised; this
neutralizes the lighting for a few seconds.
If the oven is connected to the power supply by a plug, this must remain accessible
once the oven has been fitted.
We cannot accept any liability in the event of an accident resulting from non-existent
or faulty earthing.
If the power cable is damaged, it must be replaced by the manufacturer, his
after-sales service department or similarly qualified personnel in order to avoid all risks
of danger.
88
10:56 Page 88
H o w t o i n s t a l l y o u r o v e n
We cannot accept any liability in the event of an accident
resulting from non-existent or faulty earthing.