To Assemble The Handle; To Adjust The Handle Height; To Assemble The Grass Catcher - Husqvarna LE 116P Guía De Referencia Rápida

To assemble the handle

1. Align the holes in the handlebar with the holes in the
lower handle and attach the screws, washers and
knobs. Tighten the knobs fully.
2. Attach the cables to the handle with the cable
holders.
Note: Make sure that the tension in the cables is not
too high. A too high tension can cause damage to
the cable if the handle is folded to transport position.
3. Put the cables around the hook at the bottom of the
handle.
10

To adjust the handle height

1. Loosen the lower knobs.
2. Remove the knob, washer, and screw on the left and
the right side.
3. The handle can be set to 2 different heights. Put the
screw in one of the 2 holes on the left and the right
side.
4. Attach the screws, washers and knobs.
5. Move the knobs up in the direction of the handle until
they stop and you hear a click. Tighten the knobs
fully.

To assemble the grass catcher

1. Push the 2 transportation covers out and down.
402 - 001 - 03.11.2017