Safety Instructions For Maintenance; Assembly - Husqvarna LE 116P Guía De Referencia Rápida

• Risk of electrical shock or short circuit. Do not put
objects into the air slots of the charger. Do not try to
disassemble the battery charger. Do not connect the
charger terminals to metal objects. Use an approved
mains socket.
• This product produces an electromagnetic field
during operation. This field may under some
circumstances interfere with active or passive
medical implants. To reduce the risk of serious or
fatal injury, we recommend persons with medical
implants to consult their physician and the medical
implant manufacturer before operating this product.
• Regularly make sure that the power cord of the
battery charger is not damaged and that there are no
cracks in it.
• Do not lift the battery charger by the power cord. To
disconnect the battery charger from a mains socket,
pull out the plug. Do not pull the power cord.
• Keep the power cord and extension cables away
from water, oil and sharp edges. Make sure that the
cable is not pinched in doors, fences or equivalent. It
can cause the charger to become energized.
• Do not clean the battery charger with water.
• The battery charger can be used by children aged
from 8 years and above and persons with reduced
physical, sensory, or mental capabilities or lack of
experience and knowledge if they have been given
supervision or instruction concerning use of the
battery charger in a safe way and understand the
hazards involved. Children shall not play with the
battery charger. Cleaning and user maintenance
shall not be made by children without supervision.
• Do not charge non-rechargeable batteries in the
battery charger.
• Do not use the battery charger near flammable
materials or materials that can cause corrosion. Do
not cover the battery charger. Pull out the plug to the
battery charger if there is smoke or fire.
• Do not use a defective or damaged battery charger.
• Only charge the battery indoors in a room with good
airflow and away from sunlight. Do not charge the
battery in wet conditions.
Introduction
WARNING: Before you assemble the
product, read the safety chapter.
WARNING: To prevent accidental start
during assembly, turn the safety key to 0,
remove the battery and wait at minimum 5
seconds.
402 - 001 - 03.11.2017

Safety instructions for maintenance

WARNING: Read the warning instructions
that follow before you use the product.
• To prevent accidental start during maintenance, turn
the safety key to 0 and remove the battery. Wait at
minimum 5 seconds before you start the
maintenance.
• Do the maintenance work correctly to increase the
lifetime of the product and decrease the risk of
accidents. Let an approved service agent do the
professional repairs. Speak to your nearest service
agent for more information.
• Only do the maintenance work written in this
operator's manual. More extensive work must be
done by an approved service agent.
• Put on heavy duty gloves when you use the cutting
equipment. The blade is very sharp and cuts can
easily occur.
• Keep the cutting edges sharp and clean for the best
and safest performance.
• Let your service agent regularly examine the product
and make necessary adjustments and repairs.
• Replace damaged, worn or broken parts.
• Obey the instructions for how to change accessories.
Only use accessories from the manufacturer.
• When not in operation, keep the product, battery and
battery charger apart in a dry, indoor and locked
area. Make sure that children and persons that are
not approved cannot get access to the product,
battery or battery charger.
SAVE THESE
INSTRUCTIONS

Assembly

9