To Use The Save Function; High Load Function; To Stop The Product; To Get A Good Result - Husqvarna LE 116P Guía De Referencia Rápida

To use the SavE function

The product has a battery saving function (SavE) that
gives longer operation time.
1. Press the SavE button (A) to start the function. The
green LED comes on.
2. Press the SavE button again to stop the function.
The green LED (B) goes out.
The SavE function stops automatically if the ground
conditions make it necessary to have a higher output.
The SavE function starts automatically when the ground
conditions lets it.

High load function

When the product cuts long or wet grass, the motor
automatically increases rpm. The motor goes back to
standard mode when high load is not necessary.

To stop the product

The product stops automatically if you do not operate it
for 10 minutes. Always turn the safety key to 0 before
you let the product out of view.
1. Release the motor brake handle to stop the motor.
2. Press the ON/OFF button (A) on the control panel
and the green LED (B) goes out.
B
14
A
B
A
3. Open the battery lid and turn the safety key to 0.
4. To remove the battery, press the 2 release buttons
and pull out the battery.
5. Charge the battery if it is weak. For more
To charge the battery on page 12 .
information, see

To get a good result

• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
402 - 001 - 03.11.2017