Battery Charging Status; To Use The Drive On The Wheels; To Start The Product - Husqvarna LE 116P Guía De Referencia Rápida

3. Put the battery in the battery charger. The green light
on the charger comes on when the battery is
correctly connected to the battery charger.
4. When all LEDs on the battery have come on the
battery is fully charged. Charge the battery for
maximum 24 hours.
5. To disconnect the battery charger from the mains
socket, pull the plug, not the power cord.
6. Remove the battery from the battery charger.

Battery charging status

A Husqvarna Li-ion battery can be charged or used at all
charging levels. The battery is not damaged. A fully
charged battery will not decrease its charge when the
battery is left in the charger.
LED display
LED 1 flashes
LED 1 is lit, LED 2 flashes 25%-50%
LED 1, LED 2 are lit, LED
3 flashes
LED 1, LED 2, LED 3 are
lit, LED 4 flashes
LED 1, LED 2, LED 3,
LED 4 are lit

To start the product

1. Put a charged battery in the battery compartment.
2. Turn the safety key to 1.
402 - 001 - 03.11.2017
Charging status
0%-25%
50%-75%
75%-100%
Fully charged
3. Stay behind the product.
4. Press the ON/OFF button (A) on the control panel
and the green LED (B) comes on.
B
5. Loosen the start inhibitor.
6. Push the motor brake handle in the direction of the
handlebar.

To use the drive on the wheels

• Model LE 116R. Pull the drive bail in the direction of
the handlebar to start the drive.
• Press + and - on the control panel to set the drive
speed in 4 steps.
• Release the drive bail to disengage the drive, for
example when you go near an obstacle.
A
13