Thermador PROFESSIONAL HPCN36NS Manual De Instrucciones página 19

4. Mount the bracket at the wall stud locations using (2)
1½" (38 mm) screws (provided). Ensure that the
bracket is level.
measurements in inches (mm)
Adjustable
mount holes
3½" (89) 3½" (89) 3½" (89)
Figure 23: Securing Bracket to the Wall
5. See "Hanging the Chimney Hood" on page 11 before
securing the Telescopic Chimney Extension.
6. Insert the complete duct cover at an angle and swivel
toward the wall.
2
Figure 24: Inserting Completed Cover
1
7. Carefully pull the top part of the extension upwards.
Screw the left and right sides of the extension to the
mounting bracket with the supplied stainless screws.
Figure 25: Securing Completed Cover
8. From inside of hood, screw the supplied 5/8" (16 mm)
sheet metal screws through the holes on each side and
along the front into bottom of the extension. Screw
quantity is dependent on hood size.
Figure 26: Securing Telescopic Chimney Extension to Hood
2
1
English 17