Appliance Handling Safety; Related Equipment Safety; Ventilation Safety - Thermador PROFESSIONAL HPCN36NS Manual De Instrucciones

IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
Ensure appliance is properly installed and grounded by a
qualified technician. Installation, electrical connections and
grounding must comply with all applicable codes.
If required by the National Electrical Code (or Canadian
Electrical Code), this appliance must be installed on a
separate branch circuit.
WARNING!
To reduce the risk of fire or electric shock, do not use
this appliance with any solid-state speed control
devices.

Appliance Handling Safety

CAUTION!
Unit is heavy and requires at least two
people or proper equipment to move and
install.
Hidden surfaces may have sharp edges.
Use caution when handling the appliance.
Failure to do so may result in property
damage or personal injury.

Related Equipment Safety

Never modify or alter the construction of the appliance. For
example, do not remove panels, wire covers or brackets/
screws.
CAUTION!
FOR GENERAL VENTILATING USE ONLY. Do not use
to exhaust hazardous or explosive materials and vapors.
To reduce the risk of fire, use only metal ductwork.
English 2
When cutting or drilling into wall or ceiling, be careful not to
damage electrical wiring and other hidden utilities.
Use a quali ed and trained installer.
Safety Codes and Standards
This appliance complies with one or more of the following
Standards:
• UL 507, The Standard for the Safety of Electric Fans
• CSA C22.2 No. 113, Fans and Ventilators
It is the responsibility of the owner and the installer to
determine if additional requirements and/or standards
apply to specific installations.

Ventilation Safety

WARNING!
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,
OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
• Installation work and electrical wiring must be done
by qualified person(s) in accordance with all
applicable codes and standards, including fire-rated
construction.
• Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of
fuel burning equipment to prevent back drafting.
Follow the heating equipment manufacturer's
guideline and safety standards such as those
published by the National Fire Protection
Association (NFPA), and the American Society for
Heating, Refrigeration and Air Conditioning
Engineers (ASHRAE), and the local code
authorities.
• Use only metal ductwork.
• Ducted fans must always be vented to the outdoors.
Do not vent exhaust air into spaces within walls,
ceilings, attics, crawl spaces or garages.
• When cutting or drilling into wall or ceiling, do not
damage electrical wiring and other hidden utilities.