HEINE ML4 Manual De Instrucciones página 10

Adjustment of the headband Professional L (see Fig. 4): To adjust for the head size,
the headband can be widened or tightened by turning the turnbuckles at the top (1)
and the back. (2).
Adjustment of the headband Lightweight (see Fig. 5): To adjust the head size, the
headband can be widened by pressing the lever (1) and tightened by pulling at the
free end (2).
2
3
Fig. 4 Headband Professional L (see tall fig.),
optical protection cover (see small fig.)
ML4 LED, fitting the headband rheostat
You can fit the headband rheostat (1) either on the left or the right side of the headband
(see Fig. 6). The headband rheostat (1) can then be used for stepless adjustment of the
brightness.
When using the ML4 LED, it is recommended that the mPack rheostat is set to „0" .
Fig. 6 Fitting the headband rheostat
3
10/76
1
4
2
1
med 0714
5
Fig. 5 Headband Lightweight
1
1
How to fit the LED LoupeLight to the
binocular loupe mount with HEINE i-View
(Fig. 7):
Unscrew the screw (1) on the light mount (2)
so that this can be attached to the round
attachment of the loupe mount (3). The
LED LoupeLight housing has to fit between
the eyepieces (not above them!).
The cable for the LED LoupeLight can be
fixed with the cable clip on the right or left
side of the frame as desired.
Fig. 7 Fitting the LED LoupeLight with
HEINE i-View
2016-06-30
1
®
2
®