HEINE ML4 Manual De Instrucciones página 11

Operation
HEINE ML4 LED
®
To set up the HEINE ML4 LED with HEINE mPack or HEINE EN50, connect the
® ® ®
short cord from the brightness control with the connecting cord mPack UNPLUGGED/
Cinch and fix this to the back part of the headband (Fig. 8). Connect the instrument to
the Cinch-socket of the mPack or EN 50. The rheostat (1) (Fig. 6) is used to adjust the
brightness and to turn the device on and off.
Fig. 8
To use the ML4 LED with the HEINE mPack UNPLUGGED first remove the rear cover of
®
the headband (Fig. 9).
Fig. 9
Then attach the mPack UNPLUGGED to the rear of the headband. To do so, hold the
headband in your left hand and push the mPack UNPLUGGED to the left, until it clicks
into place (Fig.10).
Fig. 10
Selecting viewing angle and field of view (Fig. 4)
Without HEINE S-Guard
®
• After loosening the locking screw (4), the light head can inclined and the angle of the
light direction can be adjusted.
• After adjustment, re-tighten the screw (4).
11/76
med 0714 2016-06-30