Lamp Replacement; Warranty - Sunoptic Surgical Titan 400HP Manual De Uso

8.1 LAMP REPLACEMENT

Ceramic lamps are at high internal pressure when cold and at operating
temperature; therefore, ceramic lamps may unexpectedly rupture
resulting in discharge of hot fragments of quartz and/or glass and
metal.
Only handle lamps with protective covers in place. Do not handle lamps
without their protective covers unless government approved safety
glasses, facemasks (with neck protector, chest protector and
gauntlets) are worn.
Always disconnect power cord and turn main switch off before lamp
replacement.
CAUTION
Take utmost care not to hit gas-seal edge of lamp; it may cause gas
lamp failure.
CAUTION
Do not touch the lamp and patient simultaneously when
changing the lamp.
CAUTION
Use only p/n SSX0040 lamp module for replacement. In order for this light source to
perform as designed, the SSX0040 must be used. Failure to use this lamp could void the

warranty.

Open lamp compartment door and pull out lamp cartridge.
Replace lamp cartridge with new unit and log the serial number and hours on the hour meter.
Close the lamp compartment door. Re-connect the power cord and turn the light source on
according to 6.1. Reset hour meter to zero by depressing hour meter reset button on rear
panel.
NOTE If the tamper seal on the lightsource is broken, the
WARRANTY WILL BE VOIDED. There are no other user serviceable parts in
the unit.
8.2 LIMITED WARRANTY
Your fiberoptic product(s) carry a 3-year warranty from the date of shipment on workmanship
and all defects of material, excluding replaceable sweatbands, headbands, fiberoptic cable and
lamps. Should your product prove to have such defects within three years of the shipment,
SUNOPTIC TECHNOLOGIES
charge. Should your fiberoptic product(s) need servicing under this warranty, please contact
SUNOPTIC TECHNOLOGIES
pack unit in a sturdy carton and ship it to the factory. Please include a note describing the
defects, your name, telephone number and a return address.
LIT124SUNOPTIC SURGICAL
(English)
WARNING
®
will repair or replace the product or component part without
®
for return authorization documentation. You should carefully
®
Warranty does not cover
Rev. I
Date of Revision: 02/08/16
Page 10 of 66