Publicidad
Insert 2 x AA batteries accordingly to right polarity (+/-). The outdoor sensor is now ready for operation and the
control LED
(41) lights up briefly.
Close the battery compartment cover.
Installing the Outdoor Sensor:
Find an appropriate place for the outdoor sensor, protected from rain and direct sun light.
Note: Please ensure that you install the outdoor sensor within a radius of 60m (open area) from the weather station.
Check that there are no obstacles between the outdoor sensor and the weather station. Otherwise there may be
interference of the transmission of data.
For wall mounting:
Hang the outdoor sensor with the mount (42) on one screw.
Preparing the weather station for use
Open the battery compartment (40) on the back of the weather station.
Insert 2 x AA batteries accordingly to right polarity (+/-).
Then close the battery compartment.
As soon as the battery safety strip has been removed, the weather station starts to
receive the radio signal.
Note: Do not move the weather station while it is receiving the signal. This may disrupt reception.
Publicidad
