Publicidad
Connecting the weather station with the outdoor sensor and the DCF radio signal:
After installing of batteries, the weather station attempts to establish a connection with the outdoor sensor. This process
can take a few minutes. The symbol will keep flashing for few minutes. On successful connection with the outdoor sensor,
the selected channel symbol (27) appears in the LC display with the channel of the outdoor sensor (if necessary you can
change the channel of the outdoor sensor as shown in the section "Setting the channel"). If the connection with the
outdoor sensor is not established automatically, this can be done manually as follows:
Press the channel button (CH) (37) short until the desired channel (27) is displayed, then press and hold the CH
button until the radio waves icon flashes. T
Then press the RESET button (43) of the sensor. Weather station outdoor temperature (25) and humidity(outdoor)
(22) will be displayed.
As soon as the weather station has established a connection with the outdoor sensor it automatically begins to
receive the DCF radio signal. This process takes several minutes and is indicated by a flashing radio tower symbol
(5).
When the DCF radio signal is being successfully received, the radio tower symbol is shown permanently in the display.
If at the time of putting the device into operation it is not possible to synchronize with the atomic clock, you can also
do the clock adjustments manually ("Setting the 12/24 hour mode /°C /°F/ hPa/ inHg/time zone /time/date/language
manually").
Publicidad
