Adjusting The Guard; Conversion From Normal Cutting To Flush Cutting - Hilti DSH 700 Manual Del Usuario

5. Check that the mounting bore of the cutting disc to be fitted corresponds with the centering collar of the
cutting disc mounting flange.
The mounting flange is equipped with a 20 mm diameter centering collar on one side and a 25.4
mm (1") diameter centering collar on the opposite side.
6. Clean the clamping and centering surfaces on the product and on the cutting disc.
7. Place the cutting disc with centering collar on the drive arbor and check that the direction of rotation is
correct.
◁ The direction-of-rotation arrow on the cutting disc must match the direction of rotation indicated on
the product.
8. Place the clamping flange and washer on the drive arbor and tighten the securing screw by turning it
clockwise.
9. Insert the locking pin in the locking hole in the drive belt cover and turn the cutting disc until the locking
pin engages.
10. Tighten the clamping screw securely (tightening torque: 25 Nm).
11. Remove the locking pin.
After fitting a new cutting disc allow the product to run at full speed under no load for approx. 1
minute.
5.2.2

Adjusting the guard

DANGER
Risk of injury. Flying fragments or sparks could cause injury.
▶ Adjust the guard so that flying particles or fragments of the material removed and flying sparks are
directed away from the operator and the product.
▶ Hold the guard by the grip provided and rotate it to the desired position.
5.2.3

Conversion from normal cutting to flush cutting

The front section of the saw arm can be converted to allow flush cuts to be made (e.g. as close as
possible to edges and walls).
▶ If you wish to use the product in the flush cutting position, have the product converted by Hilti Service.
5.3 Locking rotary movement of the guide wheels
WARNING
Risk of injury. The saw could move inadvertently or fall down.
▶ When working on roofs, scaffolds and/or on slightly sloping ground or surfaces, always take steps to
prevent rotation of the guide wheels when the saw is not in use.
1. Release the guide wheel mounting screws and remove the guide wheels.
2. Reverse the guide wheels (turn through 180°) and refit the mounting screws.
◁ The integrated locking function is active.
3. Check that the guide wheels are securely fastened.
5.4 Mounting the gasoline-powered saw on the saw trolley (accessory)
1. Remove the water tank from the saw trolley.
2. Move the cutting depth adjustment lever into the upper position.
3. Open the hold-down device by releasing the screw knob.
4. Fit the saw into the forward mount with the wheels as shown and swing the grip of the saw under the
hold-down device.
5. Secure the saw by tightening the screw knob.
6. Fit the water tank after filling it.
7. Adjust the grip to a convenient working height.
2122989
*2122989*
Printed: 17.05.2018 | Doc-Nr: PUB / 5252090 / 000 / 07
4
5
English 11