Drying Ironer Maintenance - Whirlpool MC/A 150 Instrucciones De Instalación Y De Manutención

E031002AW
- 1005 mm of circumference for ironers with 33 cm
for diametre
When changing the steel wool coverage, also
replace the sheet and
Remember to use the machine for the whole
length in order to avoid depressions on padding
(normally in the middle of the roller). For ironers
with sunction van, check every four months the
tightening of mechcanical connecting screws and
the tightening screw of the rotor on the shaft. In
case of strange noises or vibrations from the fan,
stop it immediately and make an accurate
inspection of the mechanical connections and of
the condition of the rotor. Replacement of shock
absorbers is necessary when the basin cannot
go close to the roller anymore while ironing or its
pressure is not sufficient anymore.
Leapfrogging of the movement. In case of
leapfrogging of the movement, the basin backs or
gets closer to the roller in an unccordinated way
or making noises anyway. In this case open both
the side shoulders and check the position of the
operation. Check the position of the movement: in
case of leapfrogging
disassemble it and put it back on its position. The
operation of the right side in its right position must
be like in the example above: above with closed
basin, underneath with open basin. The operation
of the left side in its right position must be like in
the example underneath: above with closed basin,
underneath with open basin.
the thick flannel.
of the mechanism,
Check also that the stops are functioning and in
their original position.

15. DRYING IRONER MAINTENANCE

Any ordinary or extraordinary maintenance must
be performed by qualfied staff. Please check that
all the connection are disconnected before
starting any operation. Clean from dust residuals
from the thermostat of the in order to keep the
contact between the pipe of the sonde and the
contacting brass plate. Regularly clean the
internal surface of the ironing roller from dust
residuals.
Grease the mechanical parts while working: the
reduction unit is a permanent lubrication and
needs no maintenance.
working period, wrap the ironing roller with a
strewed parafin powder sheet. To stretch the
introducing bands operate on the table of
introduction. The table is fixed by two sockets
head screws
To stretch the introducing bands, unloose the two
socket head screws (see example above), change
the position of the introducing table (pushing it
forwards) and screw the two socket head screws
again. Take down the introducing and collecting
slides.
To replace the introducing bands take the ones
old away. To make access easy take the cover of
the basin. Place the introducing bands among the
pin of separation underneath the introducing table.
15
24/11/04
In case of long non