Tools Needed For The Assembly; Your 3 Channel Radio System - Carson Specter Two Manual De Usuario

Tools needed for the assembly

GB
Modelling knife
Philips screwdriver
(small and big)
1,5/ 2 / 2,5 mm
C
M
Y

Your 3 channel radio system

CM
MY
Please read the instructions provided with your radio system
CY
before using it.
CMY
The servos must be set at the centre position before
installation. To set the servos at a neutral position, turn on
K
the transmitter and receiver. Set the trim levers in the center
position and turn off the receiver, and then the transmitter. The
servos will be in proper neutral position for installation.
Receiver antenna
6 Carson Specter Two
74053 Instant adhesive
Hexagonal wrench
74023
Batteries for receiver
Switch
Steering servo
Engine
throttle
servo
53339 Needle nose pliers
13118 Tweezers
Transmitter
74034 Scissors
74003 Side cutter
13305
74035