Chauvet COLORdash Par-Hex 12 Guía De Referencia Rápida página 3

COLORdash™ Par-Hex 12 QRG
AC Power
Power Linking
AC Plug
Fuse
Replacement
DMX Linking
DMX Connection
Master/Slave
Connection
This product has an auto-ranging power supply that can work with an input
voltage range of 100–240 VAC, 50/60 Hz.
To eliminate unnecessary wear and improve its lifespan, during periods of
non-use completely disconnect the product from power via breaker or by
unplugging it.
You can link up to 17 COLORdash™ Par-Hex 12 products at 120 V,
27 products at 208 V, or 30 products at 230 V. Never exceed this number.
Power linking cords can be purchased separately.
Connection
AC Live
AC Neutral
AC Ground
1. Disconnect this product from power.
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the
housing.
3. Remove blown fuse and replace with a good fuse of the same type and
rating.
4. Screw the fuse holder cap back in place and reconnect power.
The COLORdash™ Par-Hex 12 will work with a DMX controller using a
regular DMX serial connection. A DMX Primer is available from
www.chauvetprofessional.com.
The COLORdash™ Par-Hex 12 uses a regular DMX data connection for its
DMX personalities: 6 Ch, 8 Ch, 12Ch, 13Ch, HSV, and HSI. See the User
Manual to connect and configure for DMX operation.
Note: For optimum control of the 16-bit dimming channels in the 13Ch
personality, be sure that Dim mode is set to Off.
The COLORdash™ Par-Hex 12 uses the DMX data connection for its
Master/Slave mode. See the User Manual to connect and configure for
Master/Slave operation.
Wire (U.S.) Wire (Europe)
Black
White
Green/Yellow Green/Yellow
3
Screw Color
Brown Yellow/Brass
Blue
Green
EN
Silver