Operating Instructions
Operating Instructions
Remote control
The remote control and control panel will look like one of the following pictures.
2
7
4
POWER
Operation starts when this button is pressed and stops when you
press the button again.
OPERATION MODE SELECTOR
Push the MODE button to rotate between Energy Saver / Cool / Fan / Heat.
Energy Saver -
Approximately every 3 minutes the fan will turn on and check the room air
temperature if cooling is needed.
Compressor runs and cools the room.Use the
Cool -
set the desired temperature and circulation fan speed.
Fan circulates air but compressor does not run. Use the FAN button to set
Fan
-
the desired fan speed.
Heater runs and heats the room.
Heat -
ON/OFF TIMER
- when the air conditioner is off, it can be set to automatically turn
Delay ON
on from 1 to 24 hours at its previous mode and fan settings.
Delay OFF - when the air conditioner is on, it can be set to automatically turn
off from 1 to 24 hours.
FAN SPEED SELECTOR
Use to set the fan speed to Low (F1), High (F2).
TEMPERATURE CONTROL
The thermostat monitors room temperature to maintain the desired temperature.
The thermostat can be set between 60 F~86 F (16 C~30 C).
16 Room Air Conditioner
3
5
6
The fan stops when the compressor stops cooling.
REMOTE CONTROLLER
8
1
and FAN buttons to
Temp
Fan Speed
Timer
Mode
Auto
Swing