Axxess FRST-2 Instrucciones De Instalación página 8

Remapping the SWC buttons
Note, before beginning:
• The FRST-2 must have detected the vehicle and radio it is attached to before you can
remap any buttons.
• You can only start the remapping of the steering wheel controls process after
20 seconds of turning the ignition key on. If you wait longer than the 20 seconds
you will have to turn the ignition off then back on again.
• Within the first 20 seconds if any button other then "Volume Up" or "Volume Down" is
pushed, the remapping process will stop.
• If during the remapping process no button is pushed for 30 seconds the remapping
process is aborted and the original settings are reset.
Now let's begin the remapping process:
1. Ideally having the FRST-2 visible is recommended since you can see the LED flashes
to confirm button recognition.
2. Turning off the radio is recommended.
3.
After 20 seconds of turning the ignition on press and hold down the "Volume Up" button
for at least 25 seconds.
4. The LED will light up solid red. Release "Volume Up" and the LED will go out.
"Volume Up" has now been programmed.
5. Next, continue the process of remapping buttons to the SWC in order of the list below.
1
Volume Up
2 Volume Down
3
Seek Up/Next
4
Seek Down/Prev
5
Source/Mode
6
Mute
If you want to skip a command press the Volume Up on the steering wheel, this will tell
the FRST-2 to skip the command and go to the next one.
Continued on next page
FRST-2
7
Preset Up
8 Preset Down
9
Power
10 Band
11 Play/Enter
12 PTT (Push To Talk)
8
13 On Hook
14 Off Hook
15 Fan Up
16 Fan Down
17 Temp Up
18 Temp Down