Sanus BLT2 Manual De Instrucciones página 11

4
POSITION TEMPLATE
15
To calculate your precise wall plate location, check out
TIP:
our HeightFinder at sanus.com [www.sanus.com/1172].
15
Place the wall plate template
slotted holes over your stud center lines. Level and mark the hole locations.
Visit
HeightFinder™
sanus.com
/1172
at your desired height and position the
5
DRILL
4X
15
CAUTION:
Be sure you drill into the CENTER of the stud.
Drill the four pilot holes using a 7/32 in. (5.5 mm) diameter drill bit.
IMPORTANT: Pilot holes must be drilled to a depth of 2 ¾ in. (6.9 cm).
2 ¾ in. (6.9 cm)
7/32 in.
(5.5 mm)
11