Maintenance And Cleaning; Cleaning; Changing The Grinding Disk - FLORABEST FSG 85 B1 Traducción Del Manual De Instrucciones Original

GB MT
Sharpen:
9. Switch on the equipment (see "switch-
ing on and off ").
10. By putting gentle pressure on the
handle (4), move the grinding head
(2) upwards and sharpen the cutting
tooth.
Do not allow the grinding disk (18) to
slow down to standstill. This is pre-
vented by reducing the pressing force
early enough.
11. Switch off the equipment to move the
chain onwards.
Loosen the clamping lever (13) and
tighten the next chain link to be sharp-
ened in the chain guide (7) using
the adjusted chain stop (15) and the
clamping lever.
Start by sharpening the teeth on
one side of the chain. Then adjust
the rake angle and sharpen the
teeth on the other side.
Check the depth limiter distance
ƒ
(see image
The cutting links, which comprise a cutting
tooth (27) and a depth limiter lug (28), are
the sawing parts of the chain. The height
distance between these two is determined
by depth limiter distance A.
1. After every third sharpening process,
check depth limiter distance A against
the saw chain manufacturer's specifi-
cations.
2. Use a flat file to file down the height
of the depth limiter lug (28) and, after
resetting, round off the depth limiter lug
a little. The original shape must remain
intact.
48
):

Maintenance and cleaning

Disconnect the plug before adjust-
ment, maintenance or repair.
Have any work not described in
these instructions carried out by
a specialist workshop. Use only
original components. Allow the
equipment to cool before carrying
out any maintenance and clean-
ing work. There is a risk of burns.
Before each use, check the equipment
for obvious defects such as loose, worn
or damaged components and check that
screws or other parts are sitting correctly.
In particular, check the grinding disk (
18). Replace damaged parts.

Cleaning

Do not use cleaning agents or sol-
vents. Chemical substances may
attack plastic parts of the equip-
ment. Never clean the equipment
under running water.
• Clean the equipment thoroughly after
each use.
Clean the ventilation openings (
and the surface of the equipment with
a brush or cloth.

Changing the grinding disk

Instructions for changing:
• Never operate the equipment with-
out the protective screen (
• Ensure that the rotation speed
specified on the grinding disk
( 18) is equal to or greater
than the idle-running speed of
the equipment.
21)
20).