Ferm BGM1021 Traducción Del Manual Original página 3

WET & DRY BENCH GRINDER
The numbers in the following text refer to the
drawing on page 2
For your own safety and for the safety of
others, please read these instructions
carefully before using this appliance. It
will help you understand your product
more easily and avoid unnecessary risks.
Keep this instruction manual in a safe
place for future use.
Contents:
1. Machine data
2. Safety instructions
3. Installation
4. Operation
5. Maintenance
1. MACHINE DATA
Technical specification
Voltage
Frequency
Power input
No load speed
Grinding stone dimensions
Wet grinding stone dimensions
Weight
Lpa (sound pressure level)
Lwa (acoustic power)
Vibration
Load factor
A load factor of S2 = 30 min (intermittent
periodic duty) means that you may operate the
motor continuously at its nominal power level
for no longer than the time stipulated on the
specifications label (30 minutes ON period). If
you fail to observe this time limit the motor will
overheat. During the OFF period the motor will
cool again to its starting temperature.
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with
a standardised test given in EN 62841; it may be
used to compare one tool with another and as a
preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
230 V~
50 Hz
180W S1, 250W S2 30 min
2980/min
Ø 150x20 (12.7) mm
Ø 200x40 (20) mm
8.5 kg
80.7 +3 dB(A)
91.7 +3 db(A)
< 2.5 m/s
2
• using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
• the times when the tool is switched off or when
it is running but not actually doing the job, may
signifi cantly reduce the exposure level
Protect yourself against the effects of vibration
by maintaining the tool and its accessories,
keeping your hands warm, and organizing your
work patterns.
Contents of packing
1 Wet & dry bench grinder
1 Sets eye shield bracket + eye shield
1 Tool rest
1 Users manual
1 Guarantee card
Check the machine, loose parts and accessories
for transport damage.
Features
Fig. A
1. On/off switch
2. Support
3. Cover glass
4. Cover glass holder
5. Screw
6. Grinding stone wet
7. Water reservoir
2. SAFETY INSTRUCTIONS
In this manual and/or on the machine the
following symbols are used:
Denotes risk of personal injury, loss of life
or damage to the tool in case of non-
observance of the instructions in this
manual.
Indicates electrical shock hazard.
Immediately unplug the plug from the
mains electricity in the case that the cord
gets damaged and during maintenance
3