Memory Recall - HoMedics TheraP TT-200 Manual Del Usuario

MEMORY RECALL

This thermometer will automatically store the last 10 measurements
in memory. The most recent reading will automatically display when
the unit is turned on. Each new temperature reading will also be
entered into the memory as the most recent record.
When in memory mode, an arrow in the upper left corner will
appear with the memory record number to the right as shown
in the illustration below.
Indicates memory
reading and number
Press "MEM" to cycle through the records from number 0 (the most
recent reading) to number 9.
Note that when memory is at capacity, the oldest record will be
deleted to make room for a new reading.
Memory will be cleared as a result of battery removal or power
failure. A default reading of 00.0°F (00.0°C) will be displayed when
memory is cleared until a new temperature reading is taken.
HOW TO TAKE A TEMPERATURE READING
1. Always make sure that the waterproof probe has been cleaned
with a cotton swab moistened with alcohol since its previous
usage.
2. Press and release the "SCAN" button on the top of the device.
All display symbols will appear for approximately one second
(Figure 1).
Figure 1
°
°
°
7
3. When the ear thermometer is ready, the display will next show
the results of the most recent reading. The unit is ready for
measurement at this point (Figure 2).
Figure 2
Indicates a
memory
reading
4. Press and release the "SCAN" button again with the ear
thermometer outside of the ear.
In DAY MODE: An arrow symbol will appear on the
display (Figure 3).
In NIGHT MODE: In addition to the arrow symbol,
the flashlight will turn on for approximately two
seconds.
Figure 3
5. Insert the probe tip of the ear thermometer into the ear
canal within two seconds (Figure 4). It is important that
the probe tip be well positioned within the ear canal.
Measurement time for the actual reading is approx. one
second.
Figure 4
°
°
Indicates
measurement
in progress
8