Spirit
Introduction
The liquid oxygen system includes a stationary unit
and the Spirit, which provides supplementary oxygen
as prescribed by your physician. This user manual
contains the instructions for using the Spirit. Refer to
the user manual supplied with the stationary unit for
its operation.
The Spirit Portable provides an ambulatory source
of oxygen for an extended period of time. You fill
the Spirit from a liquid oxygen stationary unit.
The compact, lightweight Spirit was developed to
increase mobility and improve comfort of the typical
supplemental oxygen user.
NOTE: The service provider will assist with the initial
setup and instruct proper handling and usage of the
unit.
The Spirit Portables are intended for the administration
of supplemental oxygen to the patient in the end user's
home and can also be used in institutions such as nursing
homes or sub-acute care facilities. The device is not
intended for life support nor does it provide any patient
monitoring capabilities. The device is not for use with
tracheotomised patients. It is recommended to have an
alternate source of supplemental oxygen in the event of
mechanical failure. These Portable devices also have
a quick disconnect valve that can be coupled with a
reservoir lox device for transfilling the portable device.
The device is used by COPD patients or those with
diminished breathing capacity. The device is prescribed
to the patient. The device is sold to a provider that is
trained to operate and service the Spirit Portables. The
provider trains the user.
Spirit 600
6 - ENG
PN MN235-C4 C | User Manual
Controls
1. Contents Indicator
2. Flow Rate Selection Knob
3. Oxygen Outlet Connector
4. Fill Connections
(See next page for QDV Identification)
5. Vent Valve
6. Batteries (2) C-Cell (inside case)
3
6
5
2
1
4