Error Messages; Warning - Adam MDW-300L Serie Manual Del Usuario

9.0 ERROR MESSAGES

0ˉ ˉ ˉ ˉ ˉ
1.
0_ _ _ _ _
2.
Adˉ ˉ ˉˉ
3.
Ad _ _ _ _
4.
EEP.Er
5.
CAL.Er
6.
CAP.--
7.
Lo.bAt
8.
FULL
9.

10.0 WARNING

• Do not dismantle the weighing machine without following the necessary
instructions.
• Do not jump while standing on the platform. This may damage the sensor
inside.
• Do not move the weighing machine violently and abruptly. Always move and put
down the weighing machine gently.
• Wipe any stains with a soft damp cloth using a detergent, then wipe clean with
a dry soft cloth. Do not use organic solutions or boiling water to clean stains. Do
not use a water spray for cleaning.
• Keep the weighing machine in a dry and clean environment. Do not expose it to
outdoor use or use it in locations near fire, under direct sunshine or with high
temperature.
• When lifting the height meter, extract it directly upwards without using excessive
force.
• Do not lift the scale using the height pillar. Lift by the base only.
Zero point is over the setting range
Zero is below the setting range
ADC is over max. range;
ADC is below min. range;
There is an error in the EEPROM
There is an error in calibration
The capacity will be displayed
The battery voltage or input power is below 5.6V.
The capacity has been exceeded by the person
on the scale.
Page 15