Setting Up The Scale - Adam MDW-300L Serie Manual Del Usuario

4.0 SETTING UP THE SCALE

• Take the scale out of the box.
1. Locate the 4 screws (2)
2. Place the cable (4) through the pillar
(3).
3. Insert the 4 screws (2) through the
holes on the pillar bracket and secure
the bracket to the indicator (1),
4. Make sure the screws are securely
tightened.
5. Place the cable (4) into the tube
support (6) on the scale base.
6. Insert the pillar (3) into the tube
support (6).
7. Rotate the pillar to position the
indicator (1) in the direction desired,
and then secure using the 2 screws
(5) into the fixing tube (6).
8. Locate the load cell cable (13) ready for
connection
Page 5