Craftsman 247.240800 Manual Del Operador página 9

Note: If you decided to leave the hitch support only finger tight during the
assembly process, tighten all of the hardware securely at this time.
4. Install the bagger upright mounting bracket onto the mounting assembly of
the tractor by hooking it over the hitch plate, aligning the center hole on the
upright bracket with the hole on the cross mount bracket which corresponds
with the deck size of your tractor. See Figure 5.
• Hole A recommended for 50" & 54" decks
5. Secure the upright mounting bracket to the mounting assembly using a
(710-0276) carriage bolt and a (720-04122) wing knob from hardware pack
689-00328A. Refer to Figure 5.
NOTE: Some kits may contain cross-mount brackets with numerical
identification over the holes instead of letters as shown. If this is the case,
use the hole corresponding to the deck size the bagger is being installed on.
ASSEMBLY AND INSTALLATION
Figure 4
Figure 5
6. Using a 1/2" wrench or socket, secure the hanger assembly to the upright
mounting assembly using another (710-0276) carriage bolt from hardware
pack 689-00328A and flange lock nut packed in with the upright mounting
bracket. See Figure 6.
Note: Upon completion of this bagging unit, there will be one(1) extra wing
knob from Hardware pack 689-00328A and two(2) carriage bolts and one(1)
flange lock nut, that was packed in with the upright mounting bracket.
1
9
2
Figure 6
2