Troubleshooting Guide - Braun CareStyle 5 Serie Manual De Instrucciones

Trouble shooting guide
PROBLEM
The appliance does not switch on.
Steam comes out under the ironing
system.
There are some water drops from the
holes in the bottom of the sole plate.
Brown coloured fluid leaks from the sole
plate.
The first time the appliance is
turned on, you notice smoke
The appliance emits an intermittent
noise associated with vibrations.
The appliance emits a continuous
noise associated with vibrations.
The cleaning valve is difficult to unscrew Limescale has made the cleaning valve
After topping up with water, the light
does not reset.
All LEDs are blinking
The icons and are blinking
Subject to change without notice. Please do
not dispose the product in the household
waste at the end of its useful life. Disposal
can take place at a Braun Service Centre or
at appropriate collection points provided in your
country
CAUSE
The appliance is not plugged into a
mains socket.
The "max" pressure safety system has
opened.
Water has condensed inside the tubes
because steam is being used for the
first time, or has not been used for
some time.
Chemical water softeners or additives
have been poured into the water tank or
steam generator.
Some parts have been treated with
sealer/lubricant which evaporates the
first time the iron heats up.
Water is being pumped into the steam
generator.
difficult to open
The water float doesn't work
appropriately
System error
REMEDY
Make sure the appliance is correctly
connected and press the on/off button.
Turn the appliance off immediately and
contact an authorised Braun Customer
Services
Press the steam button several times
away from the ironing board. This will
eliminate cold water from the steam
circuit.
Never pour products into the water tank.
Clean the sole plate with a damp cloth.
This is normal and will stop when you
have used the iron a few times.
This is completely normal
Unplug the system from the mains and
contact an authorised Braun Customer
Services.
Turn the cap forcefully. To avoid the
problem, rinse the the system frequently
Empty the water tank, rinse out and refill.
Unplug the system, plug it in again and
press the on/off button. If this problem is
still present, turn the appliance off
immediately and contact an authorised
Braun Customer Service.
Unplug the system, plug it in again and
press the on/off button. If this problem is
still present, turn the appliance off
immediately and contact an authorised
Braun Customer Service.
11