Briggs & Stratton PRO1000G Manual Del Operador página 12

/
A - Oil Fill Cap -- Fill engine with oil here.
B - 0il Dipstick-- Check engine oil here.
C - Fuel Valve -- Usedto turn fuel supply on and off to
engine.
D - Oil Drain Plug -- Drain engine oil here.
E - Hour Meter -- Displays and records how many hours
your generator has run (up to 9,999.9).
F - GroundingFastener-- Consult your local agency having
jurisdiction for grounding requirements in your area.
G - Identification Label-- Provides model and serial
number of generator. Pleasehave these readily available
if calling for assistance.
H - GFCICircuit Breaker-- A GFCIcircuit breaker is
provided to protect against electrical ground fault and
protect the generator against electrical overload.
J - 120/240 Volt AC, 50 Amp Receptacle -- May be used to
supply electrical power for the operation of 120 and/or
240 Volt AC, 50 Amp, single phase, 60 Hz electrical
loads.
K - 120/240 Volt AC, 30 Amp LockingReceptacle -- May
be used to supply electrical power for the operation of
120 and/or 240 Volt AC, 30 Amp, single phase, 60 Hz
electrical, lighting, appliance, tool and motor loads.
L - 120 Volt AC, 30 Amp Locking Receptacle-- May be
used to supply electrical power for the operation of
120 Volt AC, 30 Amp, single phase, 60 Hz electrical
lighting, appliance, tool and motor loads.
M - 120 Volt AC, 20 Amp, Duplex Receptacle -- May be
used to supply electrical power for the operation of
120 Volt AC, 20 Amp, single phase, 60 Hz electrical,
lighting, appliance, tool and motor loads.
N - 12 Volt DC Receptacle -- Use this receptaclewith
battery charge cables to charge a 12 Volt battery. This
receptacle is protected by a 10 Amp auto reset circuit
breaker.
P - RockerSwitch Circuit Breaker-- The 120/240 Volt AC,
30A locking receptacleand the 120 Volt AC, 30A locking
receptacleis provided with a 2 pole rocker switch circuit
breakerto protect the generator against electrical
overload.
FI - Idle ControlSwitch -- Use this switch to turn the idle
control feature on and off.
S - Run/StopSwitch -- Set this switch to "Run" before
starting. Set switch to "Stop" to switch off engine.
T - CircuitBreakers(AC) -- The 120 Volt AC, 20A duplex
receptacle is provided with "push to reset"circuit
breakers to protect the generator against electrical
overload.
12 BRIGGSandSTRATTON.COIVl