8 Auto Standby switch (AUTO STANDBY)
Switches the Auto Standby feature on/off.
When switched ON (the default setting is OFF), the
Auto Standby feature becomes active. In this mode, if
there is no input signal for 12 minutes the system
automatically switches to standby. The power is
automatically switched on again if an input signal is
detected.
NOTE:
• There may be cases where a connected component
outputs noise or some other non-audio signal which
causes this system to automatically power on when in
Auto Standby mode. If this happens, switch off the
Auto Standby mode and switch the system on/off
manually.
9 Line Level Output terminal (LINE LEVEL OUTPUT)
Used for connecting other equipment through the
amplifier. The signal output from this jack is not
affected in any way by the settings of the various
controls on the unit.
CONNECTIONS
Before making or changing any connections, switch off the power and disconnect both this unit and the
amplifier/receiver from the AC outlet.
LINE LEVEL CONNECTION
S-LX70W/S-81W-MK
(Rear Panel)
This connection is for an amplifier or receiver equipped
with a SUBWOOFER PREOUT terminal. Connect to the
LINE LEVEL INPUT terminal on this unit, using the
specially provided RCA plug cord.
OPERATION
For details regarding operating part functions, refer to
page 6.
1. Turn the POWER switch (2) ON.
• If the unit's power cord is connected to a switched AC
outlet on the amplifier or receiver and the switch is left
ON, the unit can be turned ON/OFF together with the
amplifier or receiver.
• If the unit cannot be connected to the amplifier or
receiver, turn the power to the amplifier or receiver ON
before turning the power to the unit ON. When turning
the power OFF, turn the power to the unit OFF before
turning the power to the amplifier or receiver OFF.
All manuals and user guides at all-guides.com
10 Line Level Input terminal (LINE LEVEL INPUT)
11 AC INLET
Supplied RCA plug cord
NOTE:
• When connected to the PREOUT terminal for
2. Operate the amplifier or receiver and adjust the
3. Adjust the volume of the bass with the VOLUME
• When necessary, operate the CROSSOVER knob (4)
4. Turn the POWER switch (2) OFF.
• The power indicator disappears.
Connect to the SUBWOOFER PREOUT terminal of an
amplifier or receiver, with the specially provided RCA
plug cord.
• Connect the power cord to the powered subwoofer
unit's AC INLET.
• Connect the power cord to a AC socket.
S-LX70W/S-81W-MK
Music mode Frequency response
100
90
80
70
60
Non-bypass
50
(Crossover 200 Hz)
40
10
100
Frequency (Hz)
surround center channel on the amplifier or receiver,
the bass is heard only on the center channel, so it will
be insufficient.
volume of the other speakers.
knob (3).
and PHASE switch (7), and then adjust with the
VOLUME knob (3). Set the BASS MODE switch (6) to
either MUSIC or CINEMA.
Bypass
1000
10000
7
En