Descargar Imprimir esta página

Taurus Megane 3G Eco Turbo Manual Del Usuario página 17

Ocultar thumbs Ver también para Megane 3G Eco Turbo:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
- To use the horizontal parking
position, fix the break pad hook to the
hook situated on the rear side of the
appliance (Fig. 4)
Safety thermal protector:
- The appliance has a safety device,
which protects the appliance from
overheating.
- If the appliance turns itself off and
does not switch itself on again, dis-
connect it from the mains supply, and
wait for approximately 15 minutes
before reconnecting. If the machine
does not start again seek authorised
technical assistance.
Cleaning
Disconnect the appliance from the
mains and let it cool before underta-
king any cleaning task.
- Clean the equipment with a damp
cloth with a few drops of washing-up
liquid and then dry.
- Do not use solvents, or products
with an acid or base pH such as blea-
ch, or abrasive products, for cleaning
the appliance.
- Do not submerge the appliance in
water or any other liquid, or place it
under a running tap.
Emptying the dust box:
- Empty the vacuum deposit when
dust is visible though the transparent
walls, when it is full, or when the
vacuum cleaner does not work to its
full potential.
- Disconnect the hose from the va-
cuum cleaner's air intake. (Fig 1).
Manual Megane 3G.indb 17
- Disconnect the dust box from the
appliance. (Fig. 5)
- Open the lid of the dust box and
empty the contents into the appro-
priate waste disposal receptacle.
- Check the condition of the motor
filter.
- Close the lid of the dust box.
- Attach the dust box to the applian-
ce.
- Connect the hose to the vacuum
cleaner's air intake.
Changing the filters:
- Motor filter, it is advisable to be
changed at least once a year or every
100 hours of the appliance's use.
- Motor filter, it is advisable to be
changed at least once a year or every
100 hours of the appliance's use.
- To remove filters:
- The filter motor can be found in the
motor's turbine air entrance.
- Remove the filter from its housing.
(Fig. 6)
- To reassemble the filter, proceed
with the above instructions, in reverse
order.
Supplies
- Always use original supplies, desig-
ned specifically for your appliance
model.
Anomalies and repair
- Take the appliance to an authorised
technical support service if problems
arise. Do not try to dismantle or repair
without assistance, as this may be
dangerous.
18/07/12 12:56

Publicidad

loading