Before Starting The Equipment; Replacing The Power Cable - EINHELL TC-OS 1520 Manual De Instrucciones Original

Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vibra-
tions if the equipment is used over a pro-
longed period or is not properly guided and
maintained.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
5.1 Installing the dust extractor adapter
(Figure 2/Item 5)
Connect the dust extractor adapter (5) to the dust
extractor connector (a) as shown in Fig. 2 and
secure it by turning it. Connect the dust extractor
adapter to a suitable dust extraction system.
Important.
For health safety reasons it is imperative that you
use a dust extraction system.
5.2 Securing sanding/grinding paper using a
clamp (Fig. 3-6)
Only use sanding/grinding paper of the appropria-
te size and suitable perforations.
•
Lift the lever (7) on the front of the orbital san-
der.
•
Insert the sanding/grinding paper as far as
possible into the open clamp and close the
lever again.
•
Place the sanding/grinding paper taut over
the orbital plate (6) and clamp it again using
the second lever (7) on the rear of the orbital
sander.
•
Make sure that the perforations in the sand-
ing/grinding paper line up with the oscillating
plate.
Anl_SA_TC_OS_1520_SPK8.indb 23 Anl_SA_TC_OS_1520_SPK8.indb 23
GB
5.3 Fastening the sanding/grinding paper
with the Velcro fastening system (Fig. 6)
•
Only use sanding/grinding paper with the
corresponding dimensions and matching per-
forations.
•
Place the sanding/grinding paper onto the os-
cillating plate (6) as shown in figure 6. Make
sure that the perforations in the sanding/
grinding paper coincide with the oscillating
plate.
6. Operation
6.1 Switching the machine on and off (Fig. 7/
Item 2)
To switch on:
Slide the operating switch (2) forwards.
To switch off:
Slide the operating switch back into its initial po-
sition
6.2 Working with the orbital grinder/sander
•
Place the whole surface area of the sanding
disk on the material.
•
Switch on the machine and move it with gen-
tle pressure over the workpiece completely
circular movements or moving it to and fro
and up and down.
•
Use a coarse paper for coarse sanding and a
finer paper for finish sanding. You can find the
best paper for the job by means of testing.
Caution!
The dust generated when working with the ma-
chine may be harmful.
•
Always wear goggles and a dust mask when
carrying out sanding/grinding work.
•
Everybody who uses the machine or enters
the workplace must wear a dust mask.
•
Do not eat, drink or smoke at the workplace.
•
Do not use the machine on paints which con-
tain lead.

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by its authorized after-sales
service to avoid danger.
- 23 -
30.11.2020 13:24:36 30.11.2020 13:24:36