Rothenberger ROCLEAN Instrucciones De Uso página 10

9. Close the return / supply points. Close the water supply and remove ROPULS. The preser
vative remains in the system.
2.2 Cleaning
After completion of dosing the ROCLEAN Injector must be flushed thoroughly with clean water
(safety function). Especially paying attention to the cleaning of the tube (see picture).
2.3 Chemicals
Disinfection of drinking water pipes:
ROPULS disinfectant is a steriliazation aid for drinking water based on hydrogen peroxide. It is
chlorine-free and odorless and suitable for all pipe materials.
Safety note.
Note DVGW work sheet W 291
The steriliazation aid is suitable for sterilization according to DVGW work sheet W291. If a sterili-
zation according to DVGW work sheet W291 will conducted to ensure that the relevant guidelines
of the worksheet will be kept. If this means the ROCLEAN Injector is not possible, the sterilization
done via the injection of ROPULS and external metering (see instructions ROPULS Chapter 4.4)
Safety note.
Cleaning of heating circuits with radiators
ROPULS radiator heating circuits cleaner is a neutral cleaner for the removal of chemical contami-
nants in typical heating circuits with radiators such as scaling and encrustations. It is suitable for all
pipe materials. ROPULS cleaners should not be longer than 24 hours in the system. Safety note.
Cleaning of heating circuits with floor or space heaters
ROPULS cleaner floor heating circuits is a neutral cleaner for the removal of chemical contaminants
in typical floor / surface heating as biofilms, bacteria and accumulation of mud. It is suitable for all
pipe materials. ROPULS cleaners should not be longer than 24 hours in the system. Safety note.
Conservation of heating circuits (radiators and floor / space heaters)
ROPULS conservation medium is a tool to prevent corrosion, debris and noise in all types of boiler
hot water heating systems. It is suitable will used for all pipe materials and can be used both in
hard and soft water. The mixture is colorless and non-toxic and is discarded when emptied of hea-
ting with heating water into the public sewer. Not suitable for drinking water pipes. Safety note.
3. Disposal of rinse water
Disposal of rinse water through the sewage (wastewater) is not a problem.
8
To clean the hose (the ROPULS is no longer attached to the cleaning system!)
Give water to the rinsed bottle. Set below the output of the injrctor (right side of
ROPULS) an empty container (for example a bucket). On the ROPULS ROCLEAN
push the program button („Water unf air" permanently) turn on and operate the
fresh water supply. Catch the outcoming water from the injector with a container
and dispose it in the drainage.
Note: Always empty full bottles. Do not use it again!
Bottles are to be separated during transport from the injector!
ENGLISH