Rothenberger ROCLEAN Instrucciones De Uso página 9

4. Push the „On / Off" program key. The compressor fills the tank pressure
automatically.
5. Open the water supply. Open the pipe system.
6. Push program Key „Water and Air" (permanently). The chemistry in the bottle is supplied
to the fluid flow through. The process is stopped when the bottle is empty. For larger
systems may are several bottles required (note information on the bottle).
When changing bottles follow the instruction:
- Push program Key „Water and Air" (permanently). The compressed air supply is stopped.
- Close water supply.
- Close pipe system, so that no water flows from the system.
- Unscrew the empty bottle and replace them with new bottle.
Improper use may leak liquid from the bottle. Avoid contact with it. Note event of
accidental contact, read the specific safety instructions.
- Open pipe system.
- Open water supply.
- Press program key „water and air (permanently)".
- The chemistry in the bottle is supplied to the fluid flow through. The process is stopped
when the bottle is empty.
- Press program Key „Water and Air" (permanently). The compressed air supply is stopped.
- For optimal rinsing the chemicals should be about 45 minutes in the system. The system
must be closed for it.
7. After final rinse cleaning the system until no more chemicals are in the system. Proceed as
follows:
- ROPULS as in „first step" Mechanical cleaning of the system integrate „back into the
system (if the device has been previously disconnected from the system).
- Move the lever „rinse / ROCLEAN" position in the „flush" position.
- Press the „On / Off" push button. The compressor fills the pressure tank automatically.
- Open water supply, open piping system.
- Push program key „water and air (pulsed)" button.
- The cleaning process is completed when no more chemicals in the system.
- Turn off the ROPULS.
- Stop the water supply, close ROPULS system and remove.
Third step - preservation of the system (heating circuit):
See steps 1-5 of „second-step chemical cleaning"
8. Push program Key „Water and Air" (permanently) button. The chemistry in the bottle is
supplied to the fluid flow through. The process is stopped when the bottle is empty. For
larger systems required several bottles (note information on the bottle).
When changing bottles proceed as follows:
- Press program Key „Water and Air" (permanently). The compressed air supply is stopped.
- Close water supply.
- Close system, so that no water flows from the system.
- Unscrew the empty bottle and replace them with new bottle.
Improper use may leak liquid from the bottle. Avoid contact with it. Note event of
accidental contact, read the specific safety instructions.
- Open system / heating return flow.
- Open water supply.
- Press program key „water and air (permanently)".
- The chemistry in the bottle is supplied to the fluid flow through. The Process is completed
when the bottle is empty.
No need to change bottles
- Press program key „water and air (permanently" button). The compressed air supply is stopped.
ENGLISH 7