Resetting The Filter Change Indicator; Forced Resetting Of The Filter Change Indicator - brondell Halo PH10-B Manual Del Proprietário

RESETTING THE FILTER CHANGE INDICATOR

1. After installing the replacement filters, power the Halo on,
and press and hold the Filter Change Indicator button for
approximately two seconds.
2. The "Odor" and/or "HEPA" indicator will no longer be
illuminated.

FORCED RESETTING OF THE FILTER CHANGE INDICATOR

If, for any reason, you have replaced a filter before a Filter Change Indicator light is illuminated,
follow these steps to reset the Filter Change Indicator.
1. Ensure that the Halo is powered on.
2. Press and hold the Filter Change Indicator button for two
seconds.
3. Push the Filter Change Indicator button until the name of
the filter that was replaced is flashing.
4. Press and hold the Filter Change Indicator button for two
seconds to complete the reset.
5. If both filters were replaced at the same time, repeat
Steps 1-4 and in Step 3, choose the filter not previously
reset.
NOTE: If 10 seconds pass before a button is pressed
between Steps 3 and 4, the process is cancelled
and nothing will be reset.
Step 3
13