Cleaning The Air Sensor - brondell Halo PH10-B Manual Del Proprietário

MAINTENANCE (cont.)

CLEANING THE AIR SENSOR

Cleaning the unit while it is plugged in may result in electric shock, electric spark and
serious injury. Unplug the unit before cleaning or performing maintenance.
1. Remove the Air Sensor Cover on the side of the Halo by
pinching the tab towards the cover to relase it.
2. Clean the Air Inlets (a) and Outlet Vents (b) with a small
brush or cotton swab.
3. Wet a cotton swab lightly and clean the Lens (a), Dust Inlet
(b), and Dust Outlet (c). After cleaning, use a dry cotton
swab to remove any moisture.
4. Re-attach the Air Sensor Cover.
NOTE: Without regular cleaning of the Air Sensor, the
Halo will decline in performance.
14
Step 1
Step 2
Step 3