Remote Control; Main Unit - Jacuzzi MN35959 Manual De Usuario

Operating Instructions
Continued
Identifi cation
Note: If there is only one unit in the room, you do not need the following instructions.
• These instructions are for public toilets where more than one unit is installed. To prevent interference among units,
main unit and remote control should be set with the same ID.
• Initial ID of remote control and main unit are "0" (
How to set ID
Note: Make sure both remote and unit are set with the same ID. If they are different main unit will not work.
ID will default to ( ) if the power is unplugged or remote control batteries are replaced.

• Remote control

1. Press "Stop" for 5 seconds and
2. Press until your ID appears in display (00 ~ 15).
3. Press "Stop" again to set ID, and display will return stand-by mode.

• Main Unit

1. Plug in while pressing "Power/Bidet", main unit will beep in 5 seconds. ID setting mode will be ready
for setting.
2. ID will be changed gradually by press "Cleansing/Stop". For example: If "Cleansing/Stop" is pressed three times,
ID of main unit will be 3.
3. Press "Power/Bidet" again to set ID, and main unit will be ready in stand-by mode.
20
).
shows up in display.