Manual Operation - Petsafe Staywell 500 Infra-red Serie Guia Del Usuario

Programming the Infra-red cat fl ap
After powering the cat fl ap and the collar key, approach the cat fl ap with the
collar key. The red LED will stop fl ashing and the unit will emit a high pitched
bleep.
Your cat fl ap is now programmed to recognise the collar key and the latch
mechanism will be activated everytime you approach the cat fl ap with the
collar key. (Fig. 16). The latch will not relock until the collar key is out of
range of the cat fl ap.
If you have more than one cat, you will need to purchase collar keys of the
same colour code.
The colour codes available are: Green, Yellow, Blue and Pink.
keys can be purchased from the Staywell website -
www.staywell.co.uk
If your cat loses a collar key, you
must purchase a replacement of the
same colour. If you purchase a
different colour, you must reprogramme
the cat fl ap with that new colour.
To reprogramme the cat fl ap,
disconnect the batteries for
approximately three minutes and
follow the steps outlined on the
previous page and as above.
7
Extra
FIG.16
Attaching the Infra-red collar key
The key must be attached to the collar so that it hangs forwards (Fig. 17).
FIG. 17

Manual operation

Please note, this feature CANNOT
been fully powered and programmed. If you do not wish to use the
electronic latch the cat fl ap can be placed in manual mode.
Remove the battery cover by pushing in the direction of the arrows.
Press the manual button once (Fig. 18). and the latch will unlock and the
LED fl ashes. The cat fl ap is now in manual mode.
To place the cat fl ap back in
automatic mode press the
manual button. The latch will
relock and the LED fl ashes.
The cat fl ap is now back
in automatic mode.
be used until the cat fl ap has
FIG. 18