Levolor Cellular Shades Guia De Instalacion página 12

INSTALLATION
OUTSIDE MOUNT (OM)
Drywall
Drywall
Anchor
Anchor
STEP 2: INSTALLING THE BRACKETS
IMPORTANT: Use drywall anchors when mounting into drywall (not provided).
IMPORTANT: The rear of the brackets must be flush against a flat mounting surface.
Do NOT mount brackets on curved molding.
•
Pre-drill screw holes using a
•
Hold the bracket with the surface marked "Top" so that it is facing upwards and
then line up the pre-drilled screw holes with the holes in the bracket.
— Note: If using spacer blocks: Stack spacer blocks on the back side of the
installation brackets (see page 15 for additional details).
CAUTION: Do not use more than one spacer block. Using more than one
!
spacer block could cause shade to fall resulting in possible injury.
•
While holding the bracket in place, secure with screws, 2 screws per bracket.
•
Repeat for each bracket.
•
Use a level to confirm all brackets are level.
12 12
Cordless Lift Control
Bracket
Bracket
Screw
Screw
⁄ " drill bit, using pencil marks as a guide.
1
16