2- Installation Head Equipment; 3- Installation Transmission Equipment; 4- Instructions For Use - MSA GALLET L’COM Manual De Instrucciones

2-1 Installation head equipment:
3
10
9
FIGURE 2
Place the equipment on the head as shown in figure 2. The harness
with the nape of the neck and the strap
size of the harness (2 telescopic half-harnesses) with the two buttons
two ear trumpets lie flat on the side of the head.
Adjust the fitting of the head strap as required with the self-gripping material at each
end. Remove the equipment. Carefully push the cable
Put the equipment back on the head. Fix the cable tie clip near the collar so that when
connected the transmission equipment does not pull on the head equipment.
10
2
Ear
trumpets
10
is in contact
2 goes over the top of the head. Adjust the
3 so that the
9 back inside the nape cushion.

3- Installation transmission equipment:

FIGURE 3
5
6
7
8
INSTRUCTIONS FOR USE
4- Operation:
- Remove the protective foam from the P.T.T. button
- Switch on the transmitter/receiver
manufacturer).
- To send message, press button 6
- Release button 6 to return to receiver mode. The volume level of received message
can be adjusted with the volume knob of the transmitter/receiver
- It is better to keep the transmitter/receiver at a distance from the PTT set (risk of
interference).
Connect the connection plug
transceiver 8 (set switched off).
Fix the Telecoms case :
6
- For the clip model, on the lapel or on the belt
with the clip jaws facing upwards.
- For the belt clip model, directly on the belt.
Connect the two quick-release connectors
5 , aligning the locating pins.
6 .
(follow the instructions from the radio
8
and speak.
.
8
to the
7
11