3- Components For The F2 Helmet; Installation Head Equipment In The F2 Helmet - MSA GALLET OSTEO GA1022 Serie Manual Del Usuario

3- Components for an F2 helmet:
Reference : GA1022x2xx
1
2
Specifications
15
1 FIXING LUGS
3
5
2 HELMET-MOUNTED PICKUP
16
3 LOUD-SPEAKER
6
15 STAND-OFF
7
16 ANCHORING BRACKET FOR ANTI-TEAROUT
DEVICE
8
5 ANTI-TEAROUT DEVICE
6 SELF-BREAKING PLUG
9
7 RED LOCATING LUG
10
Specifications
FIGURE 4
8 PTT SET WITH CLIP
9 CONNECTOR PLUG
10 TRANSMITTER/RECEIVER SET (NOT SUPPLIED)
14
HEAD EQUIPMENT
TRANSMISSION EQUIPMENT
DEPENDING ON THE RADIO TYPE
4-1 Installation head equipment into an F2 helmet:
FIGURE 5
15
16
5
11
5
17
16
19
11
18
20
.
5
On the right side of the helmet, pass the
helmet-mounted pickup
11
.
Position it in the centre of the netting fabric
and feed the four fixing lugs
net 12 to ensure good contact.
3
12
Position the stand-off
loud-speaker 3 .
Hook the two ends of the stand-off
openings 17 in the helmet. The loud-speaker
3
must be positioned as shown in figure 6.
1
In order to secure the bracket for the anti-
2
tearout device 16 , take out the headband
11
bracket and cap
16
bracket together with the anti-tearout
device 5 into the housing
that its direction corresponds to the one
FIGURE 6
shown in figure 6.
3
Firmly push the equipment towards the crown
of the helmet.
Carefully slide the cable inside the holding
groove of the anti-tearout device
small length of cable
shown in figure 7.
FIGURE 7
4-2 Disassembling:
Follow the instructions for assembly in the
opposite way, disconnect the support to avoid
the cable from pulling out. Leave the this part
in the helmet.
2 under headband
1 through the
15 in the throat of the
15
into the
18 . Insert the anchoring
, making sure
19
5 leaving a
20 for manoeuvre - as
15