Graf KLARO Easy Instrucciones Para El Montaje página 58

6.3.2 Assembly of interior cabinet type 3
6. Assembling the interior switch cabinet
Lastly, the cabinet is fitted into the holes previously
made using the M8 (rough) bolts.
Alternative:
First screw the M8 bolts 15 mm into the wall and use
the slot to fit the cabinet in the wall brackets.
The switch cabinet is supplied with the rubber-metal
buffers pre-fitted. At the time of installation, be sure
that the site is sturdy (e.g. table), horizontal and level.
No additional means of fixation is needed.
57 / 144
The wall brackets
should be attached
at the holes in the
cabinet as shown
in the illustration.
The brackets are
fixed with the four
M8 (fine) bolts and
the associated
washers and nuts.
Note
For cabinets with
Becker compres-
sors, the brackets
are pre-assembled.