Graf KLARO Easy Instrucciones Para El Montaje página 62

7.4 Assembling the plastic exterior cabinet
The plastic column intended for outdoor installation should be sunk into the ground up to the mark on the
front of the cabinet. A ditch of a sufficient depth should be dug. In order to avoid overheating in summer, a
site must be chosen in which the column is not continuously exposed to direct sunlight.
Exterior column
The exterior column must be placed vertically in
the ditch to a depth of about 60–64 cm (see also
the orange mark on the column).
Make sure that the cabinet is stable and secure
and is installed vertically in the ditch.
7. Assembling the exterior switch cabinet
A ditch with the following measurements should be
prepared at the planned site:
Exterior column
Length approx. 360 mm
Width approx. 360 mm
Depth approx. 600 - 640
mm
The empty pipe and the air hoses must be routed
into the prepared ditch.
Exterior cabinet
The foundation base for the universal exterior cabi-
net must be assembled according to the accompa-
nying assembly instructions.
The cabinet must then be inserted vertically into the
ditch to a depth of approx. 60–64 cm. Make sure
that the cabinet is stable and secure and is installed
vertically in the ditch.
61 / 144
Exterior cabinet
Length approx. 585 mm
Width approx. 315 mm
Depth approx. 600 - 640
mm