Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling; Troubleshooting - EINHELL RG-ET 7535 Manual De Instrucciones Original

Anleitung_RG_ET_7535_SPK7__ 21.07.2016 15:35 Seite 15
8. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
n
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
n
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
n
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.
Use a brush to remove deposits from the safety
n
guard.
8.2 Replacing the line spool
Important. Make sure that you pull out the power
plug before replacing the line spool!
Press the sides of the spool cover as shown and
n
remove the cover (Figure 11 a).
Remove the empty line spool.
n
Thread the ends of the line on the new line spool
n
through the eyelets in the spool cover (Fig. 11b)
and allow approx. 10 cm of line to project.
Fit the spool cover and spool back into the spool
n
mounting.
When you start the equipment again the line will
n
be cut to the perfect length automatically.
Important. Bits of the nylon line could cause
injury when being flung out.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.4 Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
n
Article number of the machine
n
Identification number of the machine
n
Replacement part number of the part required
n
For our latest prices and information please go to
www.isc-gmbh.info
Spare line spool Art. no.: 34.050.60

9. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.

10. Troubleshooting

The machine will not work:
Check that the power cable is connected properly
and check the mains fuses.
If the machine will not work despite the voltage
supply being OK, send it to the specified after-sales
service address.
GB
15