Diagnostic Display - meibes Rossweiner logoplus Guia De Instalacion

7. Display options
3. Continue by pressing button > 3 seconds
*1 = If the basic display has no decimal places, then all indicated displays are shown with 3 decimal places.
*1 = If the basic display has decimal places, then all indicated displays are shown according to the basic display.

7.4 Diagnostic display

• Activate the display by pressing the button.
If a fault exists, then this is indicated by a corresponding code.
Accumulated cold volume since initial operation in m³ (for meters with heat and
cold memories) Accumulated cold volume since initial operation in m³ (for meters
with heat and cold memories) *1
Accumulated heat volume since initial operation in m³ *1
Next reading date cold energy DD. MM. YY (for meters with heat and cold
memories)
ZNext reading date heat energy DD. MM. YY
Secondary address 8 digits (the smallest number after the "S" is also used)
204 –> Overall firmware version
04 –> Firmware version for part not requiring calibration
01 –> Firmware version for part requiring calibration
55